How to Clean a Mattress (and Remove Stains and Smells)

You wash your sheets every week, but when was the last time you cleaned the mattress underneath them? A mattress collects sweat, dead skin, dust, and the occasional spill — and because it is hidden under bedding, it is easy to forget. The result is a mattress that smells musty, shows yellow stains, and feels less fresh than it should, even with clean sheets on it.

Cleaning a mattress is not hard, but it has one rule that matters more than anything else: never soak it. A mattress that stays wet grows mould. Everything below works with light moisture and plenty of drying time, and it takes about an hour of hands-on work plus a few hours for the mattress to air out.

Quick overview

  • What it is: A full mattress clean — vacuum, deodorise with baking soda, spot-clean stains, and dry properly.
  • Time needed: About 1 hour of work, plus 4 to 8 hours of drying time. Pick a morning so the mattress is dry by bedtime.
  • What you need: A vacuum with an upholstery attachment, 1 box of baking soda (about 1 cup), mild dish soap, cold water, a spray bottle, and several clean white cloths.
  • The rule: Cold water only on stains, blot — never rub — and let the mattress dry fully before you put the sheets back on.

Step 1: Strip the bed and vacuum

Take everything off the bed — sheets, mattress protector, pillows — and wash the bedding as normal. Vacuum the whole top of the mattress slowly, using the upholstery attachment. Go over it in overlapping lines, and press the attachment down gently so it picks up dust and skin from the fabric. Do the sides too, and the seams, where dust collects. If your vacuum has a crevice tool, run it along the piping and any buttons or tufts. Vacuuming first matters: if you skip it, the next steps push the dust deeper into the mattress instead of lifting it out.

Step 2: Deodorise with baking soda

Sprinkle baking soda generously over the whole top of the mattress — about 1 cup for a double bed. Baking soda absorbs odours rather than covering them, which is why it works where sprays do not. Use a sieve or a shaker jar to spread it evenly, and rub it very lightly into the fabric with your hand or a dry cloth so it reaches the surface fibres. Now leave it. Four hours is the minimum; overnight is better. The longer it sits, the more odour it pulls out. When the time is up, vacuum it all off slowly, going over the mattress twice so no powder is left behind. For a mattress that smells strongly, repeat this step a second time — a fresh layer of baking soda on a mattress that has already been treated works better than one very thick layer.

Step 3: Spot-clean stains

Work on one stain at a time, and always start with cold water — hot water sets protein stains like blood and sweat, and once set they are very hard to remove. Mix 1 teaspoon of mild dish soap into 2 cups of cold water, and put it in a spray bottle. Lightly spray the stain — damp, not wet — and blot with a clean white cloth. Work from the outside of the stain toward the centre so you do not spread it, and keep turning the cloth to a clean part. Repeat: spray, blot, turn the cloth. Never rub, which pushes the stain deeper and can damage the fabric.

  • Yellow sweat stains: The dish-soap solution above, blotted patiently, lifts most of it. Old yellow stains may fade rather than disappear entirely — that is normal, and the mattress is still clean.
  • Blood: Cold water only, straight away if you can. Blot with a cloth dampened in cold water, then use the dish-soap solution. Never use hot water on blood.
  • Urine: Blot up as much as you can first with dry cloths, pressing down hard. Then use the dish-soap solution, blot, and finish with a light spray of half water and half white vinegar, blotted dry.
  • Food or drink spills: Scrape off anything solid first, then the dish-soap solution and blotting. For coffee or tea, the same method works if you catch it before it dries.

Use a white cloth for blotting: coloured cloths can transfer dye onto a damp mattress. Keep the mattress only lightly damp throughout — if you can see water pooling, you have used too much.

Step 4: Let it dry fully

This step is as important as the cleaning. Leave the mattress uncovered with the windows open if you can, and point a fan at it. Sunlight helps if the bed is near a window — open the curtains. A mattress usually takes 4 to 8 hours to dry after spot-cleaning, depending on the room. Do not put the sheets back on until the surface feels completely dry to the touch, including the spots you cleaned. Putting bedding on a damp mattress traps moisture, and that is how musty smells and mould start. If you started in the morning, the bed should be ready by the evening.

What never to do

  • Soak the mattress: Never pour water on it or use a carpet cleaner that floods it. A wet mattress core can take days to dry and can grow mould inside where you cannot see it.
  • Hot water on blood or sweat stains: Heat sets protein stains. Cold water only.
  • Bleach: Bleach can damage the fabric and the foam inside, and it leaves a smell that lingers in a bedroom. It is not needed — the dish-soap method and baking soda do the job.
  • Steam-cleaning memory foam: Check the label first. High heat and heavy moisture can damage memory foam, so skip the steam cleaner unless the maker says it is safe.
  • Harsh scrubbing: Scrubbing frays the mattress fabric and pushes stains deeper. Blot, patiently, instead.

Keep it clean with almost no effort

  • Use a mattress protector. A washable, waterproof protector is the single best investment for a mattress: it stops sweat and spills reaching the mattress at all, and it washes in the machine. Wash it every month or two.
  • Wash your sheets every week. Clean sheets are the barrier between you and the mattress — weekly washing keeps sweat and skin from reaching it.
  • Air the bed each morning. Pull the covers back for 20 to 30 minutes before you make the bed. The mattress dries out from the night’s moisture instead of staying damp under the covers all day.
  • Vacuum the mattress every time you change the sheets. A quick two-minute vacuum while the bed is stripped stops dust building up in the first place.
  • Rotate the mattress every 3 to 6 months. Turn it end to end (and flip it if it is double-sided) so wear and body impressions spread evenly.

How often to do the full clean

Do the full vacuum, baking soda, and spot-clean routine every 6 months — spring and autumn work well. Do it sooner if there has been a spill, an illness, or a pet sleeping on the bed. Between full cleans, the weekly vacuum and the morning airing keep it fresh. Cleaning fixes smells and stains, but not structure: if the mattress sags in the middle or leaves you waking up sore, the support inside has worn out and it is time to replace it.

Vacuum, baking soda, blot the stains with cold water, and let it dry fully. That is the whole method — one morning every six months, and the mattress you sleep on is genuinely clean, not just covered up.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top